Kohler Generators 38RCLC-QS50 Details and Specifications
Kohler 38kW Generator 38RCLC + Block Heater
38kW LP/NG 120/240 Volts Single Phase Quiet 60dBA Operation
Engine Block Heater 18-Inch to Home Install 181 MPH Wind Rating RDC2 Controller
The Kohler 38kW Generator provides high quality power with advanced voltage and frequency regulation and low harmonic distortion. Neighborhood friendly operation at 60 dBA and 52 dBA during exercise. The Liquid Cooled Kohler 2.2 Liter Turbocharged Inline 4 cylinder engine provides plenty of power at 1800 RPM. The electronic governor maintains frequency within 1%. From No Load to a Full Load Condition, Total Harmonic Distortion (THC) is less than 5%.
Features a factory installed thermostat controlled Engine Block Heater for regions that fall below 32° Fahrenheit.
Meets US EPA, California, and Massachusetts emissions requirements. UL-2200 Listed.
The 38kW Kohler Generator powers all the appliances for home or business including air conditioning, heating, lights, security, and office equipment. Seconds after an outage turns out the lights, the 384RCLC restores power. Runs on Natural Gas or Propane. Includes Kohler Home Energy Management.
Kohler's Premium Limited Warranty Covers Parts, Labor, and Travel for 5-Years/2000-Hours.
Made in the USA—Kohler Manufactures the 38kW Generator in the United States.
38kW Kohler Generator Features
- Aluminum Sound Enclosure + Silencer
- Factory Installed Engine Block Heater
- UL-2200 Listed
- GFCI Service Outlet 120/240 Volt
- Integral Vibration Isolation
- Oil Drain Extension
- NEC Prime Mover Shutdown Switch
- Remote Monitoring & Control of Generator & ATS System
- RDC2 Controller + Built-In Battery Charger
38kW Generator RDC2 Digital Controller
The digital controller manages all aspects of the standby generator system. Main features include:
- Membrane Keypad
- LED Indicators
- 2 Line Backlit LCD Screen with contrast control.
- Digital isochronous governor maintains speed at all loads.
- Digital voltage regulation ±1% from no load to full load
- Programmable exerciser
- Ethernet connector
- Diagnostic Messages and Maintenance Reminders
- ATS Status and Control (RXT ATS required)
- Programmable Interface Module (PIM) Status
