ASCO Transfer Switch 97714-432 Details and Specifications
ASCO 100-Amp Automatic Transfer Switch
100-Amp ATS Service Rated NEMA 1 Indoor Only Residential or Light Commercial
100 Amp Transfer Switches ASCO 185 Series
The Service Entrance Rated ASCO 100 Amp Generator Transfer Switch serves the main circuit breaker panel with power from the utility or generator. During a power outage, the 100 Amp Automatic Transfer Switch isolates the utility from the main panel and connects the panel to the generator. Power is available to all circuits served by the main circuit breaker panel. The NEMA 1 Steel cabinet is suitable for indoor installation.
100 Amp Automatic Transfer Switch
ASCO Transfer Switches make sure the power stays on when utility power fails. When utility power returns, the ATS switches the home or business back to utility power and begins generator cool-down.
Compatible with any two-wire start system, The 100 Amp Automatic Transfer Switch monitors the utility power 24/7. When an outage occurs or power quality falls below an acceptable level, the transfer switch starts the generator and waits as the engine warms and the speed stabilizes. Once the generator is ready, the ATS isolates the utility from the subpanel and supplies generator power to the home or business.
100 Amp Transfer Switch
- The time from power failure to restoration is typically less than 30 seconds.
- Automatically switches back to utility power when it returns.
- Generator cool-down cycle before shutdown.
- User friendly control panel.
- Rated for Use as the Service Entrance Main Disconnect.
- NEMA 1 steel enclosure rated for indoor installation only.
ASCO 185 Features
- Power Status LEDs for Utility and Generator and Transfer Switch Position.
- Double Throw Contacts with Mechanical Locking Isolate Utility from Generator
- UL-1008 Listed and Meets NEC Article 702 Requirements
- 1 or 3 second time delay following outage before startup.
- Compatible with any two-wire start generator.
ASCO 185 100 Amp Transfer Switch Recommended Accessories
- The ASCO Strip Heater is recommended for extremely cold climates to prevent condensation from freezing inside the transfer switch. A frozen switch may not transfer the load to the generator during a power outage. The Strip Heater is operated by a thermostat and requires an external 120-Volt source. Available as a kit only available for mounting by the end user.
Thermostatically Controlled Strip Heater K732212-003
- The 14A/14B auxiliary contacts indicate the position of the main contacts. One contact each for the normal and emergency positions. Available as a kit only for mounting by the end user in 100-Amp, 200-Amp, and 230 Amp ASCO 185 Transfer Switches.
