ASCO Transfer Switch 97714-371 Details and Specifications
ASCO 260-Amp Automatic Transfer Switch
260-Amp ATS Non-Service Rated NEMA 1 Indoor Only Residential or Light Commercial
260 Amp Transfer Switches ASCO 185 Series
The Non-SE Rated ASCO 260 Amp Generator Transfer Switch Powers only essential or critical loads located in a subpanel served by the main circuit breaker panel. During a power outage, the 260 Amp Automatic Transfer Switch disconnects the essential load subpanel from the main panel and switches the subpanel to generator power. Only the essential and critical loads connected to circuit breakers in the subpanel receive power. The NEMA 1 Steel cabinet meets code for indoor installation.
260 Amp Automatic Transfer Switch
ASCO Transfer Switches make sure the power stays on when utility power fails. When utility power returns, the ASCO ATS switches the home or business back to utility power and begins generator cool-down.
Compatible with any two-wire start system, the 260 Amp Automatic Transfer Switch monitors the utility power 24/7. When an outage occurs or power quality falls below an acceptable level, the transfer switch starts the generator and waits as the engine warms and the speed stabilizes. Once the generator is ready, the ATS isolates the utility from the subpanel and supplies generator power to the home or business.
260 Amp Transfer Switch
- The time from power failure to restoration is typically less than 30 seconds.
- Automatically switches back to utility power when it returns.
- Generator cool-down cycle before shutdown.
- User friendly control panel.
- Not Rated for Use as a Main Disconnect.
- NEMA 1 steel enclosure rated for indoor installation only.
ASCO 185 Features
- Power Status LEDs for Utility and Generator and Transfer Switch Position.
- Double Throw Contacts with Mechanical Locking Isolate Utility from Generator
- UL-1008 Listed and Meets NEC Article 702 Requirements
- 1 or 3 second time delay following outage before startup.
- Compatible with any two-wire start generator.
ASCO 185 230 Amp Transfer Switch Recommended Accessories
- The ASCO Strip Heater is recommended for extremely cold climates to prevent condensation from freezing inside the transfer switch. A frozen switch may not transfer the load to the generator during a power outage. The Strip Heater is operated by a thermostat and requires an external 120-Volt source. Available as a kit only available for mounting by the end user.
